BPIR4T MOTION DETECTOR

Soft start motion detector with integrated temperature sensor for heaters up to 4000 watts for installation under the table.

The heater controller is part of a family of controllers designed to provide energy saving when used with Quartz Infrared Halogen Lamps. The heater controller has a built in PIR sensor allowing the lamps to automatically switch on only when people are present. In addition to the heater controller, a temperature sensor monitors the temperature and inhibits the lamps when the temperature exceeds a pre-determined set point of between 18°C and 24°C.

The microcontroller-based system incorporates zero-voltage switching and a soft-start function to eliminate the lamps’ initial high inrush current –potentially increasing lamp life by as much as 30%. The lamps are switched on for a fixed time period of 5 minutes. This period is reset each time the heater controller detects any further movement. Installation of the unit is simple and once installed is relatively maintenance-free.

Applications: Under table, under desks.

Features:

• Energy saving – only provides heat when people are present.
• Extends lamp Life.
• Temperature Sensor – lamps inhibited when ambient temperature exceeds set point.
• Soft-start/zero-voltage switch-off.
• Low-cost.
• Easy to install.
• Supply Voltage: 230VAC +/- 10% @ 50/60Hz
• Switching Capacity: 4kW Max.
• Detection Range: 5 metres
• Tolerance: +/- 1°C
• Settling Time: ≤ 20 seconds
• Detection Angle: 100°
• Temperature Set Point: 18 to 24°C
• Lamp On-Time: 5 Minutes (fixed)
• Current Consumption (control circuit): 50mA
• Terminals: 2.5mm2 Rising Clamp
• Operating Temperature: -20 to 40°C
• Gland Diameter: Max Cable Entry 2.5mm²
• Enclosure Dimensions (WxLxH): 100 x 112 x 55 (mm)